Joined: Sun Feb 15, 2009 9:32 am Posts: 120 Location: North Side
Most flat tappet setups and hyd. roller that are run under 6500 rpm can use the good (ARP) 3/8" studs with no problems. Solid roller setups with 450lb and up open spring pressures or 6500+ rpm will have more safety margin with a 7/16" stud. I have run some milder solid roller setups with 3/8" and stud girdles and survived. Flex is what eventually breaks the stud, and the damage can range from replacing a stud and pushrod all the way up to destroying a camshaft, or a block, or a complete engine.
Users browsing this forum: Bing [Bot], Yahoo [Bot] and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum