NEEDS TO GO !!! Running fine when pulled (just going to a different engine set up for my car) Everything but NO belts,plug wires,carb
SBC 355 with about 3k on re-fresh
bored .030 with flat tops
recondition stock rods
Stock crank turned 10/10
.882 heads with 2.02/1.60 valves,screw in studs and guide plates
Comp Magnum 1.52 roller rockers with polly locks
Comp 292/510 hyd. flat tappet cam with +.100 harden pushrods
Double roller timing chain
Holley single plan intake
MSD Billet dist and coil --- p/n is 8360 on dist.
Chrome timing cover and valve covers
Comes with all pulleys,alt.starter,mounts,brackets etc.
$500 FIRM takes its Need it out of my garage to make room for other stuff and will NOT take any less so dont ask me to! Everything is best to my knowledge/as is. Also traced back to the orgin. owner of the car that this engine was in (and he is a straight shooter and never gave me any reason to doubt him at all!!) Engine ran good while in my car, had a nice thump but never took it to the track nor ran it hard (pulled it from the car so I could work on other areas of the car)
PM me on the site or E-mail me at email@example.com
located in Springfield might be able to deliver if you live in Springfield only!