Page 1 of 1

need a good torque convertor if any one has one!!!!

Posted: Mon May 28, 2012 3:31 pm
by brightracing8790
I am looking for a torque convertor if any one has one. I am looking for a 4500 stall even 5000 stall my budget is 400 for that would pay up to 800 for a neal chance, I dont want junk needs to hold up to 700 plus horse so if any one knows let me know

Re: need a good torque convertor if any one has one!!!!

Posted: Mon May 28, 2012 5:03 pm
by PRO TREE
I have a Neal Chance Part #2005 SS torque converter. It is a 10 high stall race converter with a steel stator. According to their web site, this converter is built for 800+ HP for use with Nitrous, trans break or small blower. It went 5300 on the break behind a 355 in my 78 nova. It has glide splines. I will take 400$ for it. If interested, my # is 417-366-0273. Jim Kleine.

Re: need a good torque convertor if any one has one!!!!

Posted: Mon May 28, 2012 8:39 pm
by DirtFan34
I have a 8" tci race convertor stalls 4800 almost new would sell for $400. john long #417-849-6818

Re: need a good torque convertor if any one has one!!!!

Posted: Mon May 28, 2012 9:39 pm
by julven
Have you tried Marty for a new or even see what he has used?

Re: need a good torque convertor if any one has one!!!!

Posted: Sun Jun 10, 2012 1:49 pm
by bluecoupe
I have a MM converter that stalled 4500 I would sell for $350. I assume you need something for a glide?

Re: need a good torque convertor if any one has one!!!!

Posted: Sun Jun 10, 2012 7:13 pm
by brightracing8790
well you would assume correctly yes we have a glide but we have a turbo output shaft so i can use a wide variety of convertors but we have already purchased on but I may be needing another one and what gears where you running with that torque convertor? thats my biggest prob

Re: need a good torque convertor if any one has one!!!!

Posted: Sun Jun 10, 2012 10:17 pm
by Larry Jr.
your gonna need to go to the basement on your rear gears with a 377 sbc, unless your gonna smack it with spray.... your gonna need deep gears and a loose converter to make that 377 make torque in a heavier full bodied car

Re: need a good torque convertor if any one has one!!!!

Posted: Mon Jun 11, 2012 5:49 am
by bluecoupe
I had a 4:10 gear with a 28" tire with that converter behind a 422 sbf. I agree with Larry on gearing. My current combo is a 368 sbf and I have a flash of 7200 on my chance converter and run a 4:86 gear.