A place that can respline axles? it's in a low power application and would be nice to not have to spend the money to buy new axles.
Thanks David
Anyone know of....???
Moderator: opnwhl23
Anyone know of....???
74 Nova
88 mustang
88 mustang
- turbo69camaro
- Posts: 362
- Joined: Fri Feb 13, 2009 7:23 pm
Re: Anyone know of....???
I can do it what are they?
.........Confidence is the feeling you have when you don't fully understand the situation........
- turbo69camaro
- Posts: 362
- Joined: Fri Feb 13, 2009 7:23 pm
Re: Anyone know of....???
i would have to see what the spline angle is i have a 30 degree tool if not it would take me a few days to get the stuff to make a tool. ether way its 100 bucks to do a set.
.........Confidence is the feeling you have when you don't fully understand the situation........
Re: Anyone know of....???
Do i have to go with C clip eliminators or can you put a notch for the clip in also?
74 Nova
88 mustang
88 mustang
- turbo69camaro
- Posts: 362
- Joined: Fri Feb 13, 2009 7:23 pm
Re: Anyone know of....???
I can cut the groves for a little more but i would STRONGLY recommend the c clip eliminator
.........Confidence is the feeling you have when you don't fully understand the situation........
Return to “General Discussion”
Who is online
Users browsing this forum: No registered users and 5 guests